CC1800XL Core-Cut Gasoline Walk-behind Saw

FREE SHIPPING

CC1800XL Control panel with screw feed, ignition switch, adjustable handles and hour meter.  Handles have two sets of grips that can be positioned outward or inward.

CC1800XL GAS Specifications:

• 11 HP Honda GX390 Engine
• Comes with 20" blade guard
• Push Walk-behind Saw
• Heavy duty handle design
• Maximum cutting depth of 7-5/8" with 20" blade
• Left or right side sawing
• Screw feed raise and lower system
• Self-aligning blade shaft bearings
• Variety of power options
• Handles can be pointed in or out for operator ease and comfort
• Easy access to battery with heavy duty battery isolator switch to prevent battery drain
• Lifting hook standard on all models

• Maximum depth of cut with 14” blade: 4-5/8”
• Maximum depth of cut with 18” blade: 6-5/8”
• Maximum depth of cut with 20” blade: 7-5/8”
• Blade shaft RPM: 2,600
• Blade shaft diameter: 1-1/4”
• Arbor size: 1” w/drive pin
• Blade shaft drive: 3 belt for 11HP
• Blade mounting: Right or Left
• Drive Speed: 0-80 feet/min
• Fuel Capacity: 2 gallons
• Low Oil Alert: Standard



Advantages:

4-Stage Air Cleaner: The four stage dry air cleaner gives your engine the best possible protection and ensures long service life.  Includes an inner filter to safeguard your engine in the event the outer filter is torn or damaged.

Slip-on Blade Guard: Slip-on blade guard with multi-spray tubes assures your blade gets the right amount of water every time.

Lifting Hook: The entire saw can be lifted by this strong steel hook that is bolted on the saw upright.

Easy Access Engine: Oil dipstick and fill are easily found on the front of the saw which makes servicing simple.

2-Position Adjustable Handles: Along with adjusting to the operator’s height, the grips can be moved outward or inward depending on preference.



Front End Weights: Front weights are installed on the front of the saw where its needed-over the blade instead of the back which could cause unnecessary strain on the operator.

Heavy Duty Crated Steel Frame Base:  The strongest frame on the market prevents frame ‘tweaking’ from happening.  This is sometimes caused when a blade is pinched in the cut and saw could raise and slam back down on the concrete.

Don't see what your looking for?  Call us at (888) 283-2597 and we will help with any questions you may have. 

steve@acecutting.com